Power Fist 9054685 Mode D'emploi page 13

V1.0
OPERATION
The battery is not fully charged out of the carton. Charge the battery before
first use.
1. Set the tool' s trigger switch to the OFF position before installing or
removing the battery. This will help prevent injuries due to accidental
starts.
2. Check the battery power level before each use.
3. Install the battery by aligning the rib on the battery with the groove on
the battery port and push forward until the latch clicks.
4. Remove the battery by pushing the battery lock button and pulling the
battery free.
5. To facilitate cooling of the battery pack after use, avoid placing the
charger or battery pack in a warm environment such as in a metal shed or
an uninsulated trailer.
INSTALLING A DRILL BIT
WARNING! Use the correct type of drill bit for the material and speed.
The wrong drill bit can shatter and injure you or a bystander. It can also
damage the tool. Check the drill bit manufacturer's instructions to match
the bit to the task.
1. Insert the drill bit into the jaws of the chuck approximately 1 in., ensuring
that the jaws do not touch the flutes of the drill bit.
2. Before tightening the chuck, ensure that the drill bit is centered within the
jaws.
3. Tighten the chuck by hand to secure the drill bit.
SELECT THE FUNCTION
1. Select the function by turning the dial or moving the lever to the drill,
hammer or driver icon.
a. Select the drill icon when drilling a hole into wood, metal or plastic.
b. Select the hammer icon when drilling into masonry. This will activate
the hammer drill option.
c. Select the driver icon when driving a screw or bolt.
Page 13
LI-ION CORDLESS HAMMER DRILL
www.princessauto.com / 1-800-665-8685
9054685