Care & Maintenance - Power Fist 9054685 Mode D'emploi

V1.0
6. Release the trigger to stop the tool.
7. Push the trigger lock to the center position to prevent an accidental start.
8. Remove the battery pack once the job is complete and place in the
charger.
MASONRY
Drilling into brick, stone or cement requires a masonry drill bit.
1. Select the shortest masonry drill bit that will accomplish the drilling task.
Start with a short bit and switch to longer bits as the drilling progresses,
if a deeper bore hole is required.
2. Select speed 1 for high torque/low speed.
3. Follow the steps in Operating the Drill.
4. Back the drill bit out of the bore hole often during drilling to remove
debris. Clean dust and debris from the drill bit flutes from time-to-time
during the task.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Only use accessories intended for use with this tool. Follow instructions
for changing accessories.
4. Keep the tool handles or gripping surfaces clean and dry.
5. Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
6. Clear the vents of any dirt, dust and debris on a regular basis to prevent
the tool from overheating.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
Page 15
LI-ION CORDLESS HAMMER DRILL
www.princessauto.com / 1-800-665-8685
9054685