Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9054685
2.
The speed selector has two options: 1 for high torque/low speed or 2 for
low torque/high speed.
Choose setting 1 when drilling into metal, to reduce heat and drill bit
wear. This setting is also suitable when driving longer screws into harder
materials like a hardwood.
Choose setting 2 when drilling into wood or plastic. This setting may also
be used when driving shorter screws into the material, as there will be
less resistance. You can also drive longer screws with this setting if there
is a pilot hole.
SETTING THE TORQUE
Set the torque strength by aligning the dial number with the arrow.
Select a lower number when drilling or driving a screw into softer materials
and a higher number for harder materials. The clutch will slip and prevent the
screw or drill bit from penetrating the material farther.
Select a low torque to start and increase the torque when necessary. This may
prevent a situation where you drive a screw deep into the material. A low
torque may also be chosen when there is an existing pilot hole in the material.
The torque range varies depending on the speed selector switch position (see
Specifications).
OPERATING THE DRILL
1.
Position the drill bit so that it touches the workpiece.
•
Use a center punch to create an indent on harder materials to hold
the drill bit or screw in place against the material.
2.
The trigger lock has multiple positions: left for forward, center to lock
the trigger and right for reverse. Push the button to the side that is
appropriate for the task.
3.
Squeeze the trigger to start the tool.
4.
The LED worklight will illuminate the material while the trigger is held.
5.
Gently press down on the drill and allow the drill bit or the screw to
bite into the material. Control the penetration speed by increasing or
decreasing pressure on the trigger.
•
When removing a screw, apply light pressure to hold the driver bit in
place until the task is complete.
www.princessauto.com / 1-800-665-8685
LI-ION CORDLESS HAMMER DRILL
V1.0
Page 14
Publicité
Table des Matières
