Power Fist 9054685 Mode D'emploi page 10

9054685
9. Do not store the battery completely discharged. Charge it fully before
storing. Recharge occasionally if storing for a long time.
CHARGER PRECAUTIONS
WARNING! Voltage is present at the charging terminals, do not probe
with conductive objects. Electric shock or electrocution may result. A
battery short can cause a large current flow, overheating, possible burns
and even a breakdown of the tool.
1. Only use the included battery charger to recharge the battery. Other
chargers may be unsafe, causing an electrical short circuit or fire.
2. Disconnect the charger from its power source before attaching or
removing batteries or battery clamps.
3. Charge the battery in a well-ventilated area and never obstruct the vents
in the top and bottom of the charger. Place the charger on a flat non-
flammable surface and away from flammable materials when re-charging
the battery.
4. Do not place any object on top of the charger or place the charger on a
soft surface that may result in excessive internal heat. Place the charger
in a position away from any heat source.
5. Charge the battery at rates recommended by the battery manufacturer.
6. Make sure the polarity symbols on the battery lines up with the polarity
symbols of the charger. A battery inserted backwards may explode
causing fire and/or injury.
7. Do not use the charger with an extension cord. This can cause a low
voltage outage during charging.
8. Do not charge leaking batteries. A compromised casing will release
volatile chemicals and gases. Charging a leaking battery can cause a fire
or explosion.
9. Do not operate the charger if it has received a sharp blow, been dropped
or otherwise damaged in any way. Have it serviced or replaced.
VIBRATION PRECAUTIONS
1. This tool vibrates during use. Repeated or long-term exposure to vibration
may cause temporary or permanent physical injury. Take frequent breaks
when using the tool.
www.princessauto.com / 1-800-665-8685
LI-ION CORDLESS HAMMER DRILL V1.0
Page 10