Stanley SPT-163-560 Traduction De La Notice Originale page 23

5. Remove the frame cover from the underside
of the snow thrower by removing the screws
which secure the cover.
6. Remove the belt(s) from around the auger
pulley, and slip the belt(s) between the
support bracket and the auger pulley.
7. Replace the auger belt(s) by following
instructions in reverse order.
Drive Belt
If the drive belt becomes worn, oil-soaked, or
otherwise damaged, proceed as follows to
replace the belt.
1. To prevent spillage, remove all fuel from
tank by running engine until it stops.
Remove the key to avoid unintended
starting and allow unit to cool completely.
2. Remove the two screws that hold the belt
cover in place and set the cover aside.
3. Remove the belt as follows.
a. Roll the auger belt off the engine pulley.
b. Pivot the idler pulley toward the right
to relieve tension.
c. Lift the drive belt off engine pulley.
4. Carefully pivot the snow thrower up and
forward so that it rests on the auger housing.
5. Remove the frame cover from the underside
of the snow thrower by removing the screws
which secure the cover.
23
G
B