Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE CABINET
WARNING
!
The cabinet must be secured to wall studs or other
wooden framework behind the drywall to support
the weight of this unit . Failure to do so may cause
personal injury or damage to countertop or cooktop .
NOTES: A . The unit has to be installed inside the cabinet . If
installing with one of the optional liners (PM300SS
unit only), use it as a template to cut the hole in
the bottom of the cabinet .
B . The unit should be mounted centered laterally
over the cooktop burners .
C . For back to front position, the unit must be
mounted according to local building codes .
1 . Cut a hole in the bottom of the cabinet, using the
dimensions shown (FIG . 5), or use the optional liner as a
template (PM300SS unit only) .
2 . PM300SS unit only: Where needed, install the metal liner .
3 . Measure the remaining material of the cabinet bottom sides
(C) (FIG . 6), if it is 1/4" or more, there is no need to use
the cabinet brackets . Go to step 8 on page 9 .
4 . If there is less than 1/4" remaining material (C), carefully
remove those strips . Measure the cabinet inner width (D)
(FIG . 6) . Refer to the table below to see which cabinet
bracket edge configuration must be used .
U
n
nit
arrow edge
D
PM300SS
From 19-9/16"
to < 20"
D
BBN1243SS
From 22-1/16"
to < 22-1/2"
D
BBN1303SS
From 28-1/16"
to < 28-1/2"
5 . Locate the Ease of Install hooks (circled in FIG . 7) on the
unit . Temporary insert the unit in the cabinet, while holding
the unit, mark the position of the Ease of Install hooks
(shown as E in FIG . 8 on next page) on both cabinet side
walls . Remove the unit .
w
ide edge
D
From 20"
to 20-1/2"
D
From 22-1/2"
to 23"
D
From 28-1/2"
to 29"
CUT A HOLE IN THE BOTTOM OF THE CABINET
A = 10¼" (all units)
HD1381
B = 19
/
" (PM300SS)
9
16
B = 22 ¹/
" (BBN1243SS)
16
B = 28 ¹/
" (BBN1303SS)
16
HD1382
UNIT TOP VIEW
FRONT
HD1386
FIG. 5
FIG. 6
FIG. 7
7
10-0547
Publicité
Table des Matières
