Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPTIONAL LINERS
(PM300SS UNIT ONLY)
For installations where the PM300SS unit is less than 30"
above cooktop, this powerpack insert should be mounted into
a metal liner to protect cabinetry combustible material from
heat, in order to meet building code requirements . This will
allow easier cleaning and provide protection to the cabinetry .
Refer to table at right to find the liner model corresponding to
the cabinet style and width .
Visit www .broan-nutone .com or www .broan-nutone .ca to view
specific model information .
REMOVE THE CABINET BRACKETS
Detach the cabinet brackets (grey part in FIG . 2) from the back
of the powerpack insert by removing its 2 retaining screws .
Discard the screws .
Fold up and down the bracket until it is split in two separate
parts (FIG . 3) . Keep the brackets for possible further use .
NOTE: Both cabinet brackets have one wide edge and one
6
10-0547
narrrow edge (FIG . 4), to cover all installation
configurations depending on cabinet widths .
L
C
iner modeL
abinet nominaL width
LB30SS
LB36SS
SCREWS
HD1370
HO0413
Narrow edge
Wide edge
HO0408
30"
36"
FIG. 2
FIG. 3
FIG. 4
Publicité
Table des Matières
