Prepare The Unit - Broan-NuTone RHVENT 260 Instructions D'installation

PREPARE THE UNIT

NOTE: Since this manual covers different unit models, some
details in the following illustrations may slightly differ
from your unit .
1 . If present, remove all protective polyfilm from the unit and/
or parts .
2 . Remove the grease filter(s) by pulling down on tab and tilting
the filter(s) downward (FIG . 12) . Set aside the filter(s) .
3 . Disassemble the wiring compartment cover (grey part in
FIG . 13) from inside the unit by removing its retaining
screw . Remove the parts bag behind the cover . Set aside
the parts bag and the cover along with its screw .
4 . Punch out one of the two knock-out holes (grey parts in
FIG . 14) .
10
10-0547
HD1340
HD1341
HD1342
FIG. 12
SCREW
FIG. 13
KNOCK-OUTS
FIG. 14