R&G CP0256BL Instructions De Montage page 3


Place black spacer over exposed end of bolt and offer the whole bobbin assembly through hole in
fairing and locate bolt in threaded hole in metal block. Tighten the bolt until you feel some
compression from inside the protector. PLEASE NOTE BOBBIN MUST BE POSITIONED
AS PICTURED ON FIRST PAGE WITH BIGGER END TOWARD FRONT OF BIKE.
Turn a little more so that you feel the compression increase slightly. Then apply a quarter turn.
Do not overtighten as damage can occur to the bike. Do not exceed 40nm of torque.

Fit bobbin cap and bubble sticker as shown in top pictures.
Right-hand side (as you sit on bike)

Remove right-hand side fairing.

Remove the engine bolt arrowed below. DO NOT REMOVE THE SPACER.

Offer up the metal block with R-H engraved on the flat (top) surface into position shown above,
the spigot will sit in the recess where the OEM bolt used to be and the semi-circular cut-out will fit
over the frame as shown in previous picture the coolant hose will have to be moved slightly to
allow the block to sit in frame recess this is made easier by removing top screw of the lower
fairing located just behind the hose.

Fit one of the shorter of the two M10 CAP HEAD BOLTS with washer through metal block into
threaded engine mount and lightly tighten.

Slip one of the half round clamps behind frame and under wiring to line up with smaller holes in
metal block, using one long and one short M6 cap head bolts with washers through the metal
block to secure and tighten clamp.

Tighten larger cap head bolt.

Refit the lower fairing screw, note it is necessary to push the lower fairing up in to place as you
are squeezing the hose slightly this does not affect the water flow.(see picture above)

Screw marking tool (threaded bar with pointed end) into threaded hole in block with point sticking
out by approximately 25mm.

Offer fairing up to bike being careful not to damage fairing with marking tool, fix in position
using fairing screws on front half of fairing, locate rear half of fairing to fairing mounting holes,
Unit 5K, Blacknest Industrial Park, Blacknest Road, Alton, Hampshire, GU34 4PX
Tel: +44 (0)870 220 6380 Fax: +44 (0)1420 521101
R&G Racing
www.rg-racing.com Email: info@rg-racing.com