Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2 Safety notes
2.1 Correct use
Safety in operation is only guaranteed if the
solar station is used correctly. The solar station is
used to connect a solar circuit to a storage cylinder.
Any use of the solar station outside the
above applications will be considered as non-
compliant and misuse. Claims of any kind against
the manufacturer and/or his authorised
representatives due to damages caused by incorrect
use cannot be accepted.
The observance of the installation and
operating instructions is part of the compliance
terms.
2.2 Possible dangers at the installation location
and during transport The case of an external fire
has not been taken into consideration when
constructing the solar station.
s eration whe
!
WARNING
Heavy solar station!
Risk of injury! Suitable transport and lifting
devices are to be used. Wear suitable
protective clothing (e.g. safety shoes) during
installation and use safety devices. External
components like handwheels or pressure test
points must not be misused for the absorption of
external forces, e.g. as connection point for lever
tools etc.
Hot and cold surfaces!
Risk of injury! Do not touch the solar station
without safety gloves. It may get very hot or cold
during operation.
Sharp edges!
Risk of injury! Only touch with safety gloves,
Threads, bore holes and edges are sharp.
Small components!
Risk of ingestion! Store and install the
components of the solar station out of reach
of children.
Allergies!
Health hazard! Do not touch the solar station and
avoid any contact if allergies against the used
materials are known.
10
2.3 Installation, initial operation, maintenance
Installation, initial operation, maintenance and repairs
have to be carried out by authorised and qualified
tradesmen.
(EN 5011 part 1 and VDE 1000 part 10 for work on
electrical appliances).
!
WARNING
If the collector surface is heated up by hot water
returning from the storage cylinder, the permissible
excess operating pressure in the pipework
between the storage cylinder and the solar station
can be exceeded!
– Once filling and flushing has been completed, all
ball valves in the solar station (return ball valve
and the balancing valve) and in the collector
circuit (e.g. filling and flushing device) must be
opened again!
– All ball valves must be in the open position during
operation!
– The boiler must be switched off during
maintenance or repair.
– The connection between the storage cylinder
and solar station must be protected by an
additional safety valve and/or a diaphragm
expansion tank!
3 Transport, storage and
packaging
3.1 Transport inspection
Upon receipt check delivery for any damages caused
during transit and for completeness.
Any damage must be reported immediately upon
receipt.
3.2 Storage
The solar station must only be stored under the
following conditions:
– Do not store in open air, keep dry and free from
dust.
– Do not expose to aggressive fluids or heat
sources.
– Protect from direct sunlight and mechanical
agitation.
– Storage temperature: –20°C up to +60°C,
max. relative humidity of air: 95 %
3.3 Packaging material
Packaging material is to be disposed of environmen-
tally friendly.
Publicité
Table des Matières
