Operating The Hmg 510 Using Smart Sensors; Connection Diagram - HYDAC ELECTRONIC HMG 510 Mode D'emploi

11. Operating the HMG 510 using SMART sensors

SMART sensors are a new generation of sensors from HYDAC, capable of
outputting up to 10 different measured variables. Depending on the sensor
type, these variables are stored for an extended period in the unit's internal
E
memory.
Regardless of the sensor used, its parameters can be set.
The following details relate to the SMART sensor HYDACLab
however they can easily be applied to any of the other sensors.
To have the HMG 510 display the measured values of a HYDACLab
need:
 Y adapter, blue
 Sensor cable ZBE 30-0x (ZBE 30-02 included with the unit as supplied)

11.1 Connection diagram

Connect the SMART sensor to the
HMG 510 as shown in the diagram
on the right.
1. Remove the power supply from the
HYDACLab
2. Plug the Y adapter into the
HYDACLab
3. Connect the voltage supply using
connector A of the Y adapter.
4. Connect the HMG 510 using
connector B of the Y adapter.
46
.
®
.
®
®
Y adapter
HLB 1000
HLB 1000,
you
®
Power supply
HMG 510