General Operating Information - HYDAC ELECTRONIC HMG 510 Mode D'emploi

7. General operating
information
If other sensor makes are connected
to the HMG 510, the following
message appears in the display:
"err"
The HMG 510 switches off
automatically when the unit is not
used for 15 minutes.
When the HMG 510 is switched on, a
two-line display of measured values
appears:
 1st line:
Measured value on channel A +
unit of measurement
 2nd line:
Measured value on channel B +
unit of measurement
The Portable Data Recorder is only
designed for connecting HYDAC
HSI or SMART sensors featuring
automatic sensor detection.
If a channel is not being used, a
dotted line is displayed.
The battery symbol appears in the
display if the supply voltage drops
below 7 V DC. Replace the 9 V
battery in the battery compartment on
the back of the unit.
E
35