Troubleshooting; Technical Data; Disposal - SilverCrest SKM 650 A1 Mode D'emploi

Troubleshooting

If the appliance suddenly stops working:
■ The appliance has overheated and triggered the
automatic safety cut-out .
–
Turn the rotary switch 3 to "OFF" .
–
Remove the plug from the wall socket .
–
Allow the appliance to cool for 25 minutes .
–
If the appliance has not yet cooled off com-
pletely after 25 minutes, it will not start .
–
Wait a further 15 minutes and try switching
on again .
If the appliance cannot be switched on.
–
Check that the plug is correctly connected to
a wall socket .
–
Check whether the swivel arm 1 is in the
correct position .

Technical data

Input voltage:
Power consumption: 650 W
Protection class:
Max . capacity
Mixing bowl 6:
All parts of this appliance which come into
contact with food are food-safe .
We recommend the following operating times:
When working with the kneading hook 0, whisk
q or beater w, allow the appliance to cool down
for around 25 minutes after 10 minutes of operation .
If you exceed this operating time, the appliance
can overheat and be damaged!
■ 20 │ GB │ IE
220 – 240 V ∼
(alternating current),
50 – 60 Hz
II / (double insulation)
approx . 5 l

Disposal

Never dispose of the appliance
in your normal domestic
waste . This product is subject
to the provisions of European
Directive 2012/19/EU .
Dispose of the appliance through an approved
disposal facility or your municipal waste
facility . Please observe the currently applicable
regulations . Please contact your waste disposal
centre if you are in any doubt .
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out
product .
The product is recyclable, subject to
extended producer responsibility and
is collected separately .
The packaging is made from
environmentally friendly material and
can be disposed of at your local
recycling plant .
Dispose of the packaging in an
environmentally friendly manner .
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary .
The packaging material is labelled with
abbreviations (a) and numbers (b) with
the following meanings: 1–7: Plastics,
20–22: Paper and cardboard,
80–98: Composites .
SKM 650 A1