Siemens SIMATIC Rack PC IL 40 S V2 Mise En Route page 33

Certificats pour les Etats-Unis, le Canada et l'Australie
Sécurité
Si l'appareil porte l'une des marques suivantes, il est homologué en conséquence :
CEM
USA
Federal Communications
Commission
Radio Frequency
Interference Statement
Shielded Cables
Modifications
Conditions of Operations
SIMATIC Rack PC IL 40 S V2
Mise en route, Edition 06/2004, A5E00324531-01
Underwriters Laboratories (UL) selon la norme UL 60950 (I.T.E) ou selon UL508
(IND.CONT.EQ)
Underwriters Laboratories (UL) selon la norme canadienne C22.2 No. 60950 (I.T.E) ou
selon C22.2 No. 142 (IND.CONT.EQ)
Underwriters Laboratories (UL) selon la norme UL 60950, Report E11 5352 et la norme
canadienne C22.2 No. 60950 (I.T.E) ou selon UL508 et C22.2 No. 142 (IND.CONT.EQ)
UL-Recognition-Mark
Canadian Standard Association (CSA) selon la norme C22.2. No. 60950 (LR 81690) ou
selon C22.2 No. 142 (LR 63533)
Canadian Standard Association (CSA) selon la norme américaine UL 60950 (LR 81690)
ou selon UL 508 (LR 63533)
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
A.2 Certificats et homologations
Annexe
A-3