Ancona Glass Canopy 30 Mode D'emploi page 12

Step 7: Installing the decorative chimney and inner chimney bracket
• Remove the protective coating from the inner chimney. Carefully slide the inner chimney down into the
outer chimney.
• Use 2 screws (requires screw F) to fix the two chimneys together with the lower chimney bracket,
make sure inside chimney is moving freely. (See Figure #6)
• Install the chimneys on the hood. Pull out the inner chimney and adjust height according to the position
of the inner chimney bracket on the wall.
• Fix the inner chimney on the bracket with two screws (requires screw F) (See Figure #7)
6
Step 8: Installing the filter
• To install the filter follow the next three steps (See Figure #8):
- Angle the filter into slots in the left side of the hood.
- Push the button on handle of the filter.
- Release the handle once the filter fits into a resting position.
Step 9: Test hood
• Turn power On in control panel.
• Check all lights and fan operations.
• Make sure to leave this Installation Manual for the homeowner.
INSTALLATION CONTINUE:
F
12
7
8