Ancona Glass Canopy 30 Mode D'emploi page 10

Installations (refer to Page 4 for parts):
Installations (refer to Page 4 for parts):
NOTE: Use threaded drywall anchors only when
NOTE: Use threaded drywall anchors only when
mounting the hood on sheet rock. Mounting
mounting the hood on sheet rock. Mounting
the hood on wall studs or lumbars is highly
the hood on wall studs or lumbers is highly
recommended.
recommended.
Step 1: Measuring
For consumer safety reasons, mounting screws and anchors have not been supplied with this range
• Measure the distance between stove top and the bottom of range hood. A distance of 24" to 30" is
hood. Different wall and cabinetry construction methods require specific types of screws and wall
recommended with a minimum of 30" for gas stove tops.
anchors. Please consult your installation specialist regarding the best type of mounting screws
• To reach 9ft ceiling make sure hood is installed at 32" from cooking surface
and wall anchors to suit your home's construction.
• If you require longer chimney ue to reach your ceiling please contact vendor.
Step 1: Measuring
Step 2: Installing the hood mounting bracket
Measur e the distance between stove top and the bottom of range hood. A dista
•
• The range hood will be installed on top of this bracket (See Figure # 1)
recom ended with a minimum of 30" for gas stove tops. m
• Using references in Height & Clearance on Page 5 and Measurements and Diagrams on Page 16,
• To reach 9ft ceiling make sure hood is installed at 32" from cooking surface
Drill 3 holes that will be used to x the lower mounting bracket.
• If you require longer chimney flue to reach your ceiling please contact vendor.
Step 2: Installing the hood mounting bracket
Step 3: Installing the upper chimney bracket
• The range hood will be installed on top of this bracket (See Figure #1)
• Drill 2 holes according to the size of the upper mounting bracket. The upper mounting bracket
• Using references in Height & Clearance on Page 5 and Measurements and Diagrams on Page 16,
should be positioned ush with the top of the outside chimney (See Figure # 1)
drill 3 holes that will be used to fix the lower mounting bra
• Screw upper and hood mounting brackets in tightly.
Step 3: Installing the upper chimney bracket
Step 4: Installing the glass
• Drill 2 holes according to the size of the upper mounting bracket. The upper mounting bracket
• Place the glass piece over the range hood and tighten using the 4 designated screws, C & D. (See Figure #
should be positioned flush with the top of the outside chimney (See Figure #1)
• Screw upper and hood mounting brackets in tightly.
Step 4: Installing the glass
• Place the glass piece over the range hood and tighten using the 4 designated screws, C & D. (See Figure #2)
1
160
115 115
INSTALLATION:
INSTALLATION:
Flush to the ceiling
10
nce of 24" to 30" is
cket.