Table des Matières
Publicité
Chapitre 6
Entretien courant
Reversing Hinges for
Interior Door
6-6
Incubateur CO2 à jaquette d'eau
1. Open the inner door and remove inner door latch from cabinet.
2. Remove the inner door top hinge and lift the inner door off the
bottom hinge and set it aside, being very careful not to damage the
connectors on the top & bottom of the door.
3. Remove the bottom hinge.
4. Remove the plastic screws from the appropriate holes on the right
side and reinstall them in the latch and hinge holes where you just
removed the latch and hinges.
5. Install the bottom hinge in the correct position on the left side.
6. Orient the inner door properly and position it in the bottom hinge.
7. Install the top hinge.
8. Install the inner door latch on the right side, Adjust to make sure the
tab in the latch is making contact.
9. Position the cover plate under the component drawer. Be careful of
the cables. Make sure they fit into their slots.
10. Connect the cable on the top of the inner door by sliding the black
sleeve up on the yellow connector on the top of the door.
Assemble the outer door to the incubator and return the unit to
11.
service.
Thermo Scientific
Publicité
Table des Matières
