Maintenance; Storage; Service - Mi-T-M Corporation MH-0042-PM10 Manuel De L'opérateur

WARNING: FOR YOUR SAFETY DO NOT TOUCH OR MOVE THE HEATER FOR AT LEAST 45
MINUTES AFTER USE. THE REFLECTOR IS HOT TO THE TOUCH, ALLOW THE REFLECTOR
TO COOL BEFORE TOUCHING.
To enjoy years of outstanding performance from your heater, make sure you perform the following mainte-
nance activities on a regular basis:
• Keep the exterior surfaces clean.
• Use stainless steel cleaner for cleaning. Never use flammable or corrosive cleaning agents.
• While cleaning your unit, be sure to keep the area around the burner and pilot assembly dry at all
times. Do not submerge the control valve assembly. If the gas control is submerged in water, DO
NOT use it. It must be replaced.
Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean. Signs of pos-
sible blockage include:
• Gas odor with extreme yellow tipping of flame.
• Heater does NOT reach the desired temperature.
• Heater glow is excessively uneven.
• Heater makes popping noises.
• Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and
render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may
help clear away smaller particles.

STORAGE

• Carbon deposits may create a fire hazard. Clean dome and burner screen with warm soapy water if
any carbon deposits develop.
Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal. Frequently check for cor-
roded areas and repair them promptly.
Tip: Use high-quality automobile wax to help maintain the appearance of your heater. Apply to exterior surfaces from the pole
down. Do not apply to emitter screen or domes.
BETWEEN USES
• Turn control knob off.
• Disconnect LP source.
• Store heater upright in an area sheltered from direct contact with inclement weather (such as rain,
sleet, hail, snow, dust and debris).
• If desired, cover heater to protect exterior surfaces and to help prevent build up in air passages.
• Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until heater is cool completely before transporting or covering.
DURING PERIODS OF EXTENDED INACTIVITY OR WHEN TRANSPORTING:
• Turn Control Knob OFF.
• Disconnect LP source and move to a secure, well-ventilated location outdoors.
• Store heater upright in an area sheltered from direct contact with inclement weather (such as rain,
sleet, hail, snow, dust and debris).
• If desired, cover heater to protect exterior surfaces and to help prevent build up in air passages.
• Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until heater is cool before covering.

SERVICE

Repair gas passages and associated components should be done only by a qualified service person.
CAUTION: ALWAYS ALLOW THE HEATER TO COOL BEFORE ATTEMPTING SERVICE.
Propane Patio Heater Manual

MAINTENANCE

21