Mi-T-M Corporation MH-0042-PM10 Manuel De L'opérateur page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Attach cap nut and leave loose.
Place reflector center plate into middle of reflector panels and follow same procedure as above.
Repeat procedure to complete the assembly of all four sections.
Fully tighten all of the screws.
STEP 7
Attach Reflector Assembly to Studs
Support Heater.
Slide 3 large flat washers over threaded end of studs.
(6) Required Large Flat Washers
Locate Reflector Assembly on 3 studs.
Install large flat washers on studs & securely tighten wing nuts but do not over-tighten!
Propane Patio Heater Manual
ASSEMBLY
(3) Required Wing Nuts
15

Publicité

Table des Matières
loading

Table des Matières