Mi-T-M Corporation MH-0042-PM10 Manuel De L'opérateur page 14

• Load Head Assembly by inserting hose into post.
• Insert Head Assembly into post.
• Control knob should be above decal on post.
• Attach Head Assembly to post, and loosely install four small bolts.
• Tighten bolts securely.
STEP 6
Install Reflector
WARNING: REMOVE PROTECTIVE COVER BEFORE ASSEMBLY.
Note: Leave all screws and nuts loose until entire shield is put together to ensure proper alignment. Tighten after sections are
aligned.
• Slide two reflector panels together.
• Insert one small screw.
(9) Required Cap Nuts
14
ASSEMBLY
(9) Required Small Screws
Propane Patio Heater Manual