Toto Neorest WT174M Manuel D'installation Et D'utilisation page 7

Installing Toilet on the In-Wall Tank System
1) Apply lubrication using the supplied sponge in the inlet and
outlet drain to facilitate installation. Insert the inlet pipe into
the tank drain outlet until it stops.
on top of the inlet pipe. Mark the location as shown and
remove the inlet pipe.
Repeat this pr
2) Insert the inlet pipe end with the gasket into the back of the
toilet bowl.
Place the edge of a ruler against the whole width of the back
of the toilet and on top of the inlet pipe. Mark the location as
shown and remove the inlet pipe.
Repeat this pr
3) As shown in the figure, measure the distance between
two lines "a" and "b". From that dimension, mark the
cutting line by measuring from the edge opposite from
the gasket and saw off the excess.
Repeat this pr
4) Bevel the cutting edges as shown.
Screw the threaded mounting studs onto
the tank and leave 2-1/8"(54mm) exposed.
5)
appropriate drain holes.
6)
Install the toilet bowl by aligning it with the pipes
and threaded mounting stud. Use the included
mounting hardware to secure the bowl.
nished wall and
ange pipe.
ange pipe.
ange pipe.
ange pipe into the
7
Inlet Pipe
a
a + 1/8"(6mm) b + 1/4"(3mm)
1/2 c
c
Flange
Pipe
b