Spray Cleaning Solution - ECOVACS ROBOTICS WINBOT X Manuel D'instructions

Masquer les pouces Voir aussi pour WINBOT X:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 77
Attach Safety Pod
4
* Press Safety Pod to an adjacent window before cleaning. If there is
only one window, please attach Safety Pod to the corner to enhance
cleaning performance. When attaching Safety Pod, wipe it clean with
the finishing cloth to ensure good suction.
* For safety reasons, Safety Pod must be attached to an indoor window
pane.
2. Operating WINBOT

Spray Cleaning Solution

5
Spray the cleaning solution evenly on the two widest edges of the
cleaning pad. Spray each edge approximately eight times. Use the
finishing cloth to clean the cleaning pad, fan, drive treads and edge
detection sensors. This helps to prevent the robot from sliding out of
position during use.
* When spraying the Cleaning Solution, keep the spray nozzle about
1-2cm /0.39-0.78" away from the Cleaning Pad.
* It is recommended to use WINBOT with the WINBOT Cleaning
Solution from ECOVACS. Using tap water or other cleaners could
have an adverse effect on cleaning performance. Using other cleaning
solutions could potentially void the warranty.
13
EN

Publicité

Table des Matières
loading

Table des Matières