Troubleshooting - Kokido Vektro Auto RC30 Manuel D'utilisation

TROUBLESHOOTING

Problem
Robot does not capture the debris
Robot stopped moving in the middle of
pool but swivel head is still turning
Robot does not cover the entire pool /
move along the pool wall
Possible Cause
Battery is running out
Impeller is jammed
Impeller is broken
Debris compartment is full
Robot stopped by obstacle
Robot is stopped by suction
force from pool floor main drain
Debris compartment is full
Operation time is shorter as
expected
Moving direction is interrupted
by water circulation generated
by filtration system
Wheel is jammed
Locking pin position is not
correct / bumper is required
Robot moves along the pool
Solution
Charge the robot again.
Power off the robot and visually check the hole under the
swivel head to see if the impeller is jammed by larger
debris. If necessary, contact your dealer for further
instructions.
WARNING!
Make sure the robot is powered off
when the unit is being serviced.
Contact your dealer for replacement.
Clean both debris compartment and filter cover.
Check to see that if there is nothing obstructing the
cleaner. Remove the obstacle.
Turn off the filtration system as instructed in manual.
Clean the debris cleaner
Clean the filter compartment and recharge the robot
again for 4.5- 5 hrs
Turn off the filtration system as instructed in manual.
Check and clean out debris from the wheel.
Follow instruction to set up the locking pin position
properly and apply bumper .
Make sure the bumpers have been installed as instructed
15