Cavist 100 Manuel D'utilisation page 14

Installing the handle
o Remove the door gasket on the side you wish to install the handle. You can see two
designated holes for handle installation.
o Install the handle tightly as shown in the diagram above with the two screws, lock washers
and flat washers provided.
o Replace the door gasket.
Reversing the door of your wine cooler
This appliance has the capability of the door opening from either the left or right hand side.
Any parts that you remove from the appliance whilst reversing the door, should
be retained for later use.
o Open the glass door and remove the two
lock screws holding the door shaft assembly
to the glass door. Be careful to hold the glass
door firmly after removing the screws.
o Pull down to remove the glass door and
place it on a padded surface to prevent
scratching it.