Cavist 100 Manuel D'utilisation page 13

o Positioning the appliance requires two people in order to avoid injuries or damage to the
appliance.
o Your appliance should not be located in direct sunlight or exposed to continuous heat or
extremes of temperature (e.g. next to a radiator or boiler). If this is not feasible, then you
should install an insulation plate between the appliance and the adjacent heat source.
o You should check whether there is an electrical socket available, which will be accessible
after your appliance is installed.
o Place the appliance flatly and firmly on a solid base. The appliance is fitted with adjustable
feet on the front side, which can be used to level the appliance.
o When the wine cooler is being used as a freestanding unit, anything positioned above the
appliance must be at least 10 cm away to allow sufficient cooling of the condenser. You must
allow a 5 cm gap to the rear and either side of the appliance.
o Be sure to leave enough space for the opening of the door, to avoid damage to the
appliance or personal injury.
o IMPORTANT: The vent at the base of the appliance is for ventilation. Nothing should be
placed in front of this vent; otherwise your wine cooler may not operate properly.
Built-in installation
o Your wine cooler can be used as a freestanding or a built in unit. If you are going to use it
as a built in unit, then the dimensions shown in the diagram above will need to be followed.
o In particular the depth dimension must be observed.
o IMPORTANT: The vent at the base of the appliance is for ventilation. Nothing should be
placed in front of this vent; otherwise your wine cooler may not operate properly.