Cavist 100 Manuel D'utilisation page 11

o To remove any of the shelves from the rail compartment, move the shelf to the
position where the notch of wooden shelf is exactly under the plastic post and
lift the wooden shelf. Please ensure these are replaced when the shelf is put
back.
o Make sure the shelves are fully engaged before loading any bottle into the
cooler. Pull the shelves out all the way to the STOP position and push them
back in several times to make sure the shelves are properly engaged.
Moving your wine cooler
If you need to move your wine cooler to another location you should follow the steps
outlined below.
o Remove all items from the wine cooler.
o Securely tape down all loose items such as the shelves inside the appliance.
o Turn the adjustable foot up to the base to avoid damage.
o Tape the door closed.
o Be sure the appliance stays secure in the upright position during transportation.
Also protect the outside of the appliance with a blanket or similar item.
Power failure
o Most power failures are corrected within a few hours and should not affect the
temperature of your appliance if you minimize the number of times the door is
opened.
o If the power is going to be off for a longer period of time, you need to take the
proper steps to protect the contents.
IMPORTANT: If the appliance is unplugged, the power is lost or turned off you must
wait 3 to 5 minutes before restarting the wine cooler. If you attempt to restart before
this time delay, the wine cooler will not turn on.
Vacation time
Short holidays: Leave the wine cooler in operation for holidays of less than three
weeks.
Long absences: If the appliance will not be used for several months, remove all items,
turn off the appliance and unplug the electricity cable. Clean and dry the interior
thoroughly. To prevent odour and mould growth, leave the door open slightly by
blocking it open if necessary.