Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSERTING/REMOVING BEATERS & DOUGH HOOKS
Before releasing the Beaters or Dough Hooks, switch off the Mixer and remove the
plug from the electrical outlet.
Push the Beaters or Dough Hooks into the slots on the underside of the mixers, until
they click into place. The two Dough Hooks have different plug shapes and must be
pushed into the correct slots. Inserting the wrong way would lead the dough to "move"
upwards. One of the Dough Hooks has an additional small ring near the collar on the
shaft. This Dough Hook will only fit in the slot for which it is intended.
To remove the accessories, hold firmly with one hand, while pressing the Beater
Ejector Button (figure 3).
Before using your Hand Mixer for the first time, wash the Beaters in hot/ soapy water,
or the dishwasher. Rinse and dry.
Be sure the speed controls are in the "0" position and the unit is unplugged from an
electrical outlet. Plug cord into an electrical outlet. Insert Beaters as indicated above.
Ensure the Mixer is switched off before raising/ lowering. Press the Raise/ Low
Button (figure 4) and lift the Mixer up or lower it until it clicks in place. This will
facilitate removal of Beaters as well the Bowl.
CONNECTION
RAISING/LOWERING THE MIXER
Figure 3
Figure 4
E n g li s h -5
Publicité
Table des Matières
