Lighting Instructions - Napoleon MIRAGE 485 Instructions De Montage Et D'utilisation

LIGHTING INSTRUCTIONS

LIGHTING INSTRUCTIONS ARE ALSO LOCATED
UNDER SIDE BURNER LID.
OPEN LID.
ENSURING BURNER CONTROLS
ARE IN THE OFF POSITION, TURN
ON THE GAS SUPPLY VALVE.
ACTION WILL IGNITE THE PILOT
IF THE PILOT LIGHTS, CONTINUE
3. IF THE PILOT AND BURNER WILL
NOT IGNITE WITHIN 5 SECONDS,
TURN THE CONTROL KNOB TO THE
OFF POSITION AND WAIT 5 MINUTES
FOR ANY EXCESS GAS TO DISSI-
PATE. EITHER REPEAT STEPS 1 AND
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames will be achievable.
If lighting the unit with a match, clip the match into the supplied lighting rod. Hold the
lit match down through the grill and sear plate while turning the corresponding burner
valve to high.
MAIN BURNER LIGHTING
1. PUSH AND TURN ANY MAIN
BURNER KNOB SLOWLY TO
THE HIGH POSTION. THIS
FLAME WHICH WILL IN TURN
LIGHT THE SELECTED BURNER.
TO PUSH DOWN ON THE
CONTROL KNOB UNTIL THE
BURNER LIGHTS AND THEN
RELEASE.
2. IF THE PILOT DOES NOT
IGNITE, THEN IMMEDIATELY
TURN THE CONTROL KNOB
BACK TO THE OFF POSITION
AND REPEAT STEP 1 SEVERAL
TIMES.
2 OR LIGHT WITH A MATCH.
CENTER BURNER
LEFT BURNER
SIDE BURNER LIGHTING
1. OPEN SIDE BURNER
2. PUSH AND TURN THE
SIDE BURNER CONTROL
KNOB SLOWLY TO THE
HIGH POSITION. THIS
ACTION WILL IGNITE
3. IF THE BURNER DOES NOT
IGNITE, THEN IMMEDIATELY
TURN THE CONTROL KNOB
BACK TO THE OFF POSITION
AND REPEAT STEP 2 SEVERAL
4. IF THE BURNER WILL NOT IGNITE
WITHIN 5 SECONDS, TURN THE
CONTROL KNOB TO THE OFF
POSITION AND WAIT 5 MINUTES
FOR ANY EXCESS GAS TO
DISSIPATE. EITHER REPEAT STEPS
2 AND 3 OR LIGHT WITH A MATCH.
RIGHT BURNER
SIDE BURNER
COVER.
THE SIDE BURNER
TIMES.
5