Lighting Instructions - Napoleon PRO 500 Mode D'emploi

8

Lighting Instructions

EN
WARNING!
WARNING!
gas supply valve.
2. Push and turn any main burner knob
slowly to the high position. If the pilot
lights, continue to push down on the
control knob until the burner lights and
immediately turn the control knob back to
the 'off' position and repeat step 2 several
4. If the pilot and burner will not ignite
within 5 seconds, turn the control knob to
the 'off' position and wait 5 minutes for any
excess gas to dissipate. Either repeat steps
5. If lighting the unit with a match, clip the
match into the supplied lighting rod. Hold
the lit match down through the grill and
sear plate while turning the corresponding
WARNING!
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
www.napoleongrills.com
Side
Burner
Left
Left Centre
Igniter
Burner
Open lid
Ensure all burner controls are in the off position. Slowly turn on the
Main Burner
Lighting
1. Open grill lid.
then release.
3. If the pilot does not ignite, then
times.
2 and 3 or light with a match.
burner valve to high.
The propane cylinder is equipped with an excess flow device. Unless all burners are
Do not use rear burner while operating main burner.
Right Centre Rear
Burner Burner Burner
Rear Burner Lighting
(if equipped)
1. Open grill lid.
2. Remove warming rack.
3. Turn rear burner control to high
position.
4. Press and hold
igniter button until burner lights, or
light by match.
5. If ignition is not immediate, turn
burner control off. Wait 5 minutes.
Repeat.
Lights
Right
Burner
Off Position
Side Burner Lighting
(optional)
1. Open burner cover.
2. Turn side burner control to high
position.
3. Press and hold
igniter button until burner lights, or light
by match.
4. If ignition is not
immediate, turn burner control off.
Wait 5 minutes. Repeat.