Keysight 53220A Mode D'emploi page 124

3 53220A/53230A Measurements
Burst Pulse Measurements
Microwave (burst) pulse measurements are available on channel 3 Option 106
(6 GHz Microwave Input) or Option 115 (15 GHz Microwave Input) with pulse
measurement Option 150.
The pulse measurements covered in this section include: burst carrier frequency,
pulse repetition interval (PRI), pulse repetition frequency (PRF), positive (on)
width, and negative (off) width.
a burst signal.
The SCPI commands listed in these examples are provided as an introduction to
NOTE
how measurements involving microwave pulses are made. Commands may be
included even though they specify default values - but which should be
considered when modifying the examples for actual use. Refer to the
Programmer's Reference for additional information.
For further information on microwave measurements, see Application Note
200-1 "Fundamentals of Microwave Frequency Counters".
124
Figure 3-13 identifies these measurements within
Keysight 53220A/53230A User's Guide