Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Service
WARNING
cause serious hazard.
Service Center or Autho rized Skil Service Station.
Tool Lubrication
Your Skil tool has been properly lubricated and is ready to use. It is recommended that tools
with gears be regreased with a special gear lubricant at every brush change.
Carbon Brushes
The brushes and commutator in your tool have been engineered for many hours of
dependable service. To maintain peak efficiency of the motor, we recommend every two to six
months the brush es be examined. Only genuine Skil replace ment brushes specially designed
for your tool should be used.
Bearings
Bearings which become noisy (due to heavy load or very abrasive material cut ting) should be
replaced at once to avoid overheating or motor failure.
Cleaning
WARNING
cleaned most effectively with compressed dry air.
ing tools with compressed air.
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects through openings.
CAUTION
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and house
hold detergents that contain ammonia.
14
Preventive maintenance performed by unauthorized per so n nel may
result in misplacing of internal wires and components which could
We recommend that all tool service be performed by a Skil Factory
To avoid accidents always disconnect the tool from the power supply
before cleaning or performing any maintenance.
Certain cleaning agents and solvents damage plastic parts.
Always wear safety goggles when clean-
The tool may be
Some of
Publicité
Table des Matières
