Installation And Adjustment; Installation Of Window Sealing Accessories - HTW P31 Manuel De L'utilisateur

V. Installation and adjustment
1.Installation：
Warning: before using the unit, keep it upright for at least two hours.
The unit can be easily moved in the room. In the moving process, ensure that the unit is in the upright position
and should be placed on a flat surface. Do not install and use the unit in the bathroom or other humid
environments.
1.1 Install the heat pipe assembly （as shown in Fig.1）
1）take out the outer connector assembly and the exhaust pipe assembly, and remove the plastic bags;
2）insert the heat pipe assembly (the end of the exhaust joint) into the back panel vent slot (push to the
left) and complete the assembly (as shown in figure 1).

1.2 Installation of window sealing accessories

There are two options to seal the window for better exhaust of hot air
1.2.1 Window plate for sliding windows
1 ） Half open the window ， and mount the window sealing plate assembly to the window (as shown in Fig.2 and
Fig.3).Components can be placed in horizontal and vertical direction.
2 ） Pull various components of the window sealing plate assembly open, adjust their opening distance to bring
both ends of the assembly into contact with the window frame, and fix various components of the
assembly.1.2 Install the window sealing plate assembly
Notes: 1: The flat end of the exhaust pipe joints must be snapped into place.
2: The pipe cannot be distorted nor has substantial turning (greater than 45 ° ). Keep the ventilation of
the exhaust pipe unblocked.
Figure 2
Figure 1
Figure 3
27