Use; Audio Settings; Audio Return Channel (Arc); Audio Format Settings - Marmitek Connect AE24 UHD 2.0 Guide Utilisateur

5

Use

5.1

Audio settings

Select the desired audio settings by using the EDID and ARC
buttons at the front of the Connect AE24 UHD 2.0™.
5.1.1

Audio Return Channel (ARC)

If your AV amplifier is connected via the "Audio out", there may be
a slight lag between your TV's image and the sound coming from
the AV amplifier. This is caused by image processing on your TV
and is sometimes referred to as lip sync problem. The
Connect AE24 UHD 2.0™ supports ARC (Audio Return Channel).
This involves the sound first being sent to the TV, and then
returned by your TV at exactly the right moment, using the same
HDMI cable. This allows you, without the use of additional wiring
or settings, to synchronise images and sound. The "ARC" switch
allows you to enable or disable this feature.
ARC must be supported by your TV to be able to use this feature.
If your TV does not support ARC, you can either turn off image
processing on your TV, or delay the audio coming from your AV
amplifier or HDMI source. Please refer to your device's manual for
the correct settings.
5.1.2

Audio format settings

Using the EDID button, you can set the desired audio format for
your audio equipment. In standard situations, it will be sufficient to
select OUTPUT 1 or 2. However, should you experience any
problems, please select another format manually.
Output 1 automatically detects the best possible audio format

that is supported by your TV.
Output 2 automatically detects the best possible audio format

that is supported by your AV receiver.
7.1CH supports up to HD audio.

5.1CH supports up to DTS and Dolby Digital/AC3 audio.

2.0CH supports 2-channel audio.

Connect AE24 UHD 2.0™ 11