Sirius SLT966 Instructions D'utilisation Et Avis De Montage page 16

TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the
European Commission, which came into force
as from January 1st, 2015 , our products have
been adapted to comply with these new re-
quirements.
All of the models complying with the energy
label requirements, are equipped with new
electronics including a timer device for suc-
tion speeds control, when the air capacity ex-
ceeds 650m³/h.
Internal motor models, with maximum air
capacity higher than 650m³/h, are equip-
ped with a timer device that automatically
switches the suction speed from 4th to 3rd
speed, after 5 minutes operation.
External motor models are equipped with
remote motors that , as for internal motor
versions, include a timer device that switches
down the suction speed when it exceeds 650
mᵌ/h. (See External Motors Instructions )
Remote motors, whose air capacity exceeds
650m³/h at both 4th and 3rd speed , will
have the following by default timer control
functions: The suction speed is automatically
switched from 4th to 2nd speed, after 6 mi-
nutes operation.
If the appliance is working at 3rd speed, it is
automatically switched to 2nd speed, after 7
minutes operation. Operation speeds can
also be changed during operation.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.
MAINTENANCE
An accurate maintenance guarantees good
functioning and long-lasting performance.
A special care must be paid with grease fil-
ters: to remove the grease filter please follow
the instructions given in the 'USES' section ,
according to the model chosen.
An accurate maintenance guarantees good
functioning and long-lasting performance.
* Particular care is due to the grease filter The
grease filter is fixed through magnets, there-
fore it is sufficient to insert a hand tool or the
tip of a knife in the dedicated opening and
push upwards in order to pull the filter out
of its place. See Fig. 8 In order to remove the
filter from the hood, unhook the two security
cables opening their snap-hooks, The active
coal filter has to be removed after the extrac-
tion of the grease filter by pusing the specific
handle (fig.9. The grease filter can be clea ned
by hand-washing or in dishwashers..
The active coal filter has to be replaced in re-
lation to its use, at least once every six mon-
ths. To clean the appliance itself tepid wa-
ter and neutral detergent are recommended,
while abrasive products should be avoided.
To reinsert the grease filter after the cleaning,
just perform the opposite operation.
To clean the appliance itself tepid water and
neutral detergents are recommended, while
abrasive products must be avoided.
The power-supply cable must be replaced by
authorised qualified staff only.
16