Checking the DC voltage
When placing the probes on an AC voltage within the rated voltage
range, one of the lower (12V +~-) LED's and the LED arranged
above it illuminate according to the voltage applied. The lower
LED's indicate the polarity at the test probes in accordance with
the identification! (+,−)
If the threshold value of 35 V is exceeded, a signal sounds and lucid
vibration can be felt. This indicates a general hazardous voltage!
Checking the AC voltage
When placing the probes on an AC voltage within the rated voltage
range, both of the lower (12 V +~-) LED's and the LED's arranged
above them illuminate according to the voltage applied. Simulta-
neous illumination of the lower LED's indicates AC voltage (~).
If the threshold value of 35 V is exceeded, a signal sounds and lu-
cid vibration can be felt. This indicates a general hazardous volt-
age!
Phase test
Contact a conductor with the test probe "L2". If a phase is applied,
min. 100 V~, the "<L"-LED illuminates!
For determining the phase conductor, the perceptibility of the indi-
cation can be impaired, e.g. by insulating fixtures to protect
against direct contact in adverse positions, for example on wooden
ladders or insulating floor coverings, of a voltage not earthed or
also in adverse lighting conditions.
25