General; Function; Self-Test - Berner Multitester LED Plus II Manuel D'utilisation

Correct indication is ensured in the
|
temperature range of −10 °C
Always keep the device dry and clean.
|
The housing can be cleaned using a
moist cloth.
The additional warning symbol, acoustic
|
indications and vibration for voltages
> 35 V are only for warning of hazard-
ous voltages, not for measurement.
Before the test, check the audibility of the
|
warning sound at the ambient volume.
Immediately replace the batteries when
|
a continuous warning signal sounds
when switching on.

General

Voltages have priority. If no voltage is applied at the measuring
probes (< 3 V), the device is in the continuous test mode. In
stand-by mode, the orange "Rx/" illuminates.

Function

To switch on the device, simply hold the test probes on one another.
Attaching and removing the measuring probe adapter makes it
easier to carry out measurements at the socket.
Indication of the voltage is carried out without the batteries.

Self-test

For the test, keep the probes apart. The green "Rx/" LED must
clearly illuminate and a beep tone sounds. (After a short period,
the device automatically switches off by the "Auto Power Off" func-
tion.) If the LED does not illuminate, or only faintly illuminates, re-
place the batteries.
If the device does not function with the new batteries, it must be
protected from misuse.
+55 °C.
–
24