Operation; Safety Instructions - Berner Multitester LED Plus II Manuel D'utilisation

Operation

Thank you very much for deciding on the Berner Multitester LED
Plus II, a two-pole voltage tester with LCD display. DC voltages of
6V to 1400V and AC voltages of 6 V to 1000 V, polarity, rotating
field and continuity tests of up to 50  can be carried out and
FI/RCD tests.
Because of the high protection class (IP65), the Berner Multitester
LED Plus II can also be used under rugged conditions.

Safety instructions

You have decided on a device that provides a high degree of safety.
In order to ensure safe and correct application, before initial use, it
is necessary to completely read these operating instructions.
The following safety precautions are appli-
cable:
Immediately before using, carry out a
|
function check of the voltage tester
(VDE regulation 0105, Part 1). Make
sure that the connecting lines and de-
vice are fully serviceable. Check the de-
vice on a known source of voltage,
e.g. 230 V socket.
Hereby, if the display fails to indicate one
|
or more functions, do not use the device
and it must be checked by a specialist.
Only hold the device by the handles,
|
avoid touching the probes!
Only carry out checks for isolation from
|
the power supply on both poles!
The device must not be operated in a
|
moist environment!
Do not use with the battery compart-
|
ment open! Whilst replacing the bat-
tery, the measuring probes must be
removed from the measurement circuit.
23