Shelves And Shelf Frames - Jennair KBSD706MPS Manuel D'utilisation

Small Items Bin
To remove and replace the small items bins:
1. Remove the bin by lifting it up and pulling it out.
2. Replace the bin by sliding it in above the desired support and
pushing it down until it stops.
3. Install the Small Items Bin in the top spot of the door.
Shallow Door Bins
To remove and replace the shallow door bins:
1. Remove the bin by lifting up and pulling out.
2. Replace the bin by sliding in above the desired support and
pushing down until it stops.
Gallon Door Bin
1. Install the bin on the lower door support only.
2. Position bin above lowest door adjustment slot.
3. Push down to secure bin.
To remove and replace the gallon door bins:
1. Remove the bin by lifting up and pulling out.
2. Replace the bin by sliding in above the desired support and
pushing down until it stops.

Shelves and Shelf Frames

To remove and replace a shelf/frame:
1. Remove the shelf/frame by tilting it up at the front and lifting it
out of the shelf supports. Pull shelf straight out.
2. Replace the shelf/frame by guiding the rear shelf hooks in to
the shelf supports. Tilt the front of the shelf up until the rear
shelf hooks drop into the shelf supports.
3. Lower the front of the shelf and check that the shelf is in
position.
Pull Out Tray
Remove and Replace:
1. Remove food from tray.
2. Pull drawer out about 4" (10.16 cm).
6
3. Reach under the tray with both hands and lift gently upward
until front of shelf is free. Tilt the shelf at an angle and remove
the shelf from the refrigerator.
4. Tilt the shelf at an angle and position it above the support rails.
5. Place shelf gently on support rails on side wall.
Marinating Pan
To remove and replace Marinating Pan:
1. Remove the marinating pan by lifting it up off the brackets.
Press the right-hand side of the pan inward until it is free of its
bracket. Lower the right-hand side slightly and disengage the
left-hand side from its bracket.
2. Replace the marinating pan by inserting the left-hand side into
its bracket. Press inward on the right-hand side until it will
slide past the bracket edge and set it into its bracket.
NOTE: Remove everything that is below (pans/bucket) and above
the Marinating Pan before removing it.
For 36"
For 42"
For 48"
To purchase additional bakeware please visit:
https://www.kitchenaid.com/kitchenware/bakeware.html
Remove and Replace the Top Drawer Cover
1. Remove food from Top drawer cover. Pull drawer out about 4"
(10.16 cm). Reach under the glass shelf with both hands and
lift gently upward until back of shelf is free. Tilt the shelf at an
angle and remove the shelf from the refrigerator. Be sure not
to bump the glass.
2. Replace the cover by holding the glass shelf firmly with both
hands, tilt the shelf at an angle and position it above the
support rails. Place shelf gently on support rails on side wall.