Num'axes EYENIMAL PET CLIPPER Guide D'utilisation page 11

CHOOSE THE APPROPRIATE HAIR LENGTH SETTING
Press the adjustment button on the front of the appliance and slide it to the desired position:
Slide up to reduce the space between the blades
̵
Slide down to increase the space the blades
̵
Start at the setting for maximum hair length (19 mm)
to familiarise yourself with the clipper.
MOUNTING THE COMB
Make sure the clipper is off.
Hold both side of the comb, place it into the notch in front of the clipper head.
REMOVING THE COMB
Make sure the clipper is off.
Pull the locked part of the comb avoiding pressing the front
or rear of the comb for not damaging
Clean the appliance every time you have used it.
1. Before cleaning the device, make sure that it is disconnected and off.
2. Remove the comb by following the instructions of the figure above. Be careful not to drop blades on the
floor.
3. Clean the hair with the brush supplied, avoiding touching the springs and the structure.
4. After cleaning the blades, put a little drop of oil between the 2 blades to lubricate them for next use.
5. Return the blades to their original position by pressing until "click".
COMB MOUNTING
CLEANING
down blade
Ceramic blade
up blade
Steel blade
11