Num'axes EYENIMAL PET CLIPPER Guide D'utilisation page 10

CHARGING THE CLIPPER
1. Make sure the clipper is off while charging.
2. Connect the charging jack into the receptacle at the end of the clipper.
3. Plug the adaptor unit into the electric outlet.
4.. Place the clipper into the charging unit.
5. The charging icon is lighting while charging.
A complete charge takes approximately 3 hours and allows you until
5 hours of use.
CORDED CLIPPING
To use the pet clipper connected to the mains:
1. Switch the pet clipper off.
2. Connect it to the mains and wait a few seconds before switching it on. If the battery is completely empty,
wait a few minutes before switching the appliance on.
Do not run the appliance from the mains when the battery is fully charged.
BATTERY LED DISPLAY INDICATOR
Indicator shows status description while charging
Fig 1. The battery is insufficiently charged (less than 5%).
Fig 2. The battery is charged between 5% and 20%.
Fig 3. The battery is charged between 20% and 60%.
Fig 4. The battery is charged between 60% and 100%.
* The battery is fully charged while all indicators steady light.
* The battery automatically goes into standby mode when the clipper is disconnected and inactive.
10