Correct Handling Of Machine; Points In Operation And How To Stop - Dolmar MS-335.4 U Mode D'emploi Original

CORRECT HANDLING OF MACHINE

Attachment of shoulder strap
– Adjust the strap length so that the cutting tool will be kept
parallel with the ground.
For MS-335.4 U
NOTE: Be careful not to trap clothing, etc., in the buckle.
Detachment
For MS-335.4 C
– In an emergency, push the notches (1) at both sides, and you can detach the
machine from you.
Be extremely careful to maintain control of the machine at this time. Do not allow
the machine to be deflected toward you or anyone in the work vicinity.
WARNING: Failure to maintain complete control of the machine at all could result in
serious bodily injury or DEATH.
For MS-335.4 U
– In an emergency, push the notches (2) at both sides, and
you can detach the machine from you.
Be extremely careful to maintain control of the machine
at this time. Do not allow the machine to be deflected
toward you or anyone in the work vicinity.
WARNING: Failure to maintain complete control of the
machine at all could result in serious bodily
injury or DEATH.

POINTS IN OPERATION AND HOW TO STOP

Observe the applicable accident prevention regulations!
STARTING
Move at least 3 m away from the place of refuelling. Place the String Trimmer on a clean piece of ground taking care that the cutting tool does
not come into contact with the ground or any other objects.
A: Cold start
1) Set this machine on a flat space.
2) Set the I-O switch (1) to OPERATION.
3) Choke lever
Close the choke lever.
Choke opening:
– Full closing in cold or when the engine is cold.
– Full or half opening in restart just after stop of operation.
(2)
Lock-off lever
OPERATION
STOP
High speed
Low speed
Throttle lever
MS-335.4 C
(1)
14
(1)
Hanger
STOP
Throttle lever
OPERATION
Low speed
High speed
Buckle
MS-335.4 U
(1)
Lock-off lever
MS-335.4 U
CLOSE