Mounting Of Nylon Cutting Head - Dolmar MS-335.4 U Mode D'emploi Original

Masquer les pouces Voir aussi pour MS-335.4 U:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MOUNTING OF NYLON CUTTING HEAD

Turn the machine upside down, and you can replace the nylon cutting head
easily.
– The nylon cutting head should go on top of the receiver washer (1).
– Insert the hex wrench through the hole in the gear case and rotate the
receiver washer (1) until it is locked with the hex wrench.
– Then screw the nylon cutting head onto the shaft by turning it counter-
clockwise.
– Remove the hex wrench.
(1)
Hex wrench
Rotation
11
Loosen
Tighten

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ms-335.4 c

Table des Matières