Publicité
switch to " Gold-Run" . GBC
mode switch to " Gold" and the
The
" ready" LED will illuminate when
with your GBC No-Heat
Laminate or other pressure-
non-thermal
sensitive,
laminating pouch.
1. Slide the mode switch to
illuminate in approximately
two to seven minutes after
on.
the machine is turned
2. Trim and place GBC Creative
Foil on toner-printed areas as
desired. Foii should be
with adhesive dots provided
if necessaty.
3. Cover the document and foil
with a sheet of the Paper that
between the sheets of foil.
4. Place the document, foil and
that is also provided with the
foils.
5. Insert the carrier and its
contents straight into the
machine.
6. The item will automatically
exit the rear of the pouch
has stopped moving, remove
it from the machine and allow
it to cool for about 30
seconds. This cooling
securely affixed to the
document. Remove the
document from the carrier.
I' interruttore su " Gold-Run"
(Esegui a freddo). DocuSeal
I' interruttore di modo su " Cold
(Freddo) e quelle a bilanciere
su " Run" (Esegui). li LED
Seguire
Ie pouches ,GBC No-Heat -:"; ..
Laminate oppure con altre non
, : F& &?la& l,i&;r&fio-&i'
modo su." Foil" (Foglio ' - :. .' -
. . -bilankiere su Wun" (Esegui).
minuti circa dall' accensione
e posizionario come . -b":.i::. . :
desiderato sulle aree
stampate con il toner. Fare
colorato rivolto Verso I' alto. ' -1
adesivi circolafi fornj$ a.tale
3. Coprire il documktö-i il
foglio metallizzato con uno .-
dei fogli di carta' contenuti_. - 1::.
. +:
Publicité
