Maintenance And Inspection - ALFRA TML 1000 Mode D'emploi

MAINTENANCE AND INSPECTION OF THE LIFTING MAGNET
The user is obliged to maintain and service the lifting magnet in compliance with the
specifications in the operating manual and according to the country-specific standards and regulations
(e.g. ASME B30.20B, DGUV-Information 209-013; AMVO).
The maintenance intervals are classified according to the recommended schedule.
Before every use...
• visually inspect the lifting magnet for damage
• clean the surface of the workpiece and the underside of the magnet
• free the underside of the magnet of rust, chips or unevenness
• verify the lock function of the safety tab on the lever
Weekly...
• inspect the lifting magnet and load hook for deformation, cracks or other defects
• make sure that the operating lever and safety tab are working properly
• inspect the load hook for damage or wear and have it replaced if necessary
• inspect the bottom of the magnet for scratches, pressure points or cracks and have the magnet repaired by
the manufacturer if necessary
Monthly...
• check the markings and labelling on the lifting magnet for legibility and damage and replace them if
necessary
Annually...
• have the load-bearing capacity of the lifting magnet checked by the supplier or an authorized workshop
• inspect the load hook thoroughly for damage, cracks or wear and have it replaced if necessary
After 5 years or 20.000 lifting operations
• After a maximum of 5 years or 20.000 lifting operations the load hook must be replaced with a new one by
the manufacturer or an authorized workshop (thread locking adhesive, mediumstrength; 100 Nm torque).
An annual inspection is recommended for the safe use of this lifting magnet.
You will then promptly receive an offer and have the assurance that the lifting magnet will be
inspected in a process-reliable manner where it was actually produced.
Unauthorized repairs or modification to the lifting magnet are not permitted.
!
If you have any questions contact the manufacturer.
20
We will be glad to perform this inspection for you in-house.
Please send us an email to:
TML-Test@alfra.de