Maintenance And Inspection - ALFRA TMH 50 Mode D'emploi

MAinTenAnce And inspecTiOn OF THe HAnd-OpeRATed LiFTing MAgneT
The user is obliged to maintain and service the hand-operated lifting magnet TMH 50 in compliance with
the specifications in the operating manual and according to the country-specific standards and regulations
(e.g. ASME B30.20B, DGUV-Information 209-013; AMVO).
Before every use...
• visually inspect the hand-operated lifting magnet for damage
• clean the surface of the workpiece and the underside of the magnet
• free the underside of the magnet of rust, chips or unevenness
weekly...
• inspectthe lifting magnet and activation lever for deformation, cracks or other defects
• make sure the activation lever is working properly and latches correctly into place
• inspect the bottom of the magnet for scratches, pressure points or cracks. Have the magnet repaired
by the manufacturer if necessary
Monthly...
• check the markings and labelling on the lifting magnet for legibility and damage and replace them
if necessary
Annually...
• have the load-bearing capacity of the lifting magnet checked by the supplier or an authorised workshop
unauthorised repairs or modification to the lifting magnet are not permitted.
!
if you have any questions, contact the manufacturer.
16