Calibration - INTEGRA Metering AMFLO SONIC Smart Instructions De Montage Et Mode D'emploi

6.1 Decommissioning
• Disconnect all sources of energy.
• Remove the device from the system.
6.2 Disposal
At the end of its life cycle, this product should be disposed of according to local
regulations regarding waste recycling or disposal.
Batteries and rechargeable batteries shall be recycled separately.
The separate collection and recycling of used products will help to conserve natural re-
sources, and ensures that they are disposed of in a way that does not cause damage to
the environment and nature.
7

Calibration

Conformity assessed AMFLO
cablibration after the expiration of this deadline. Concerning this the following steps are
required
1. Place AMFLO
quired.
2. Connect AMFLO
chapter 3. For this purpose the data /pulse value on the type plate is relevant.
3. Fill the measuring pipe with a medium.
4. Start the flow.
5. Perform the measurement for calibration/testing according to the required stand-
ard / guideline in compliance with the required test conditions and references.
6. End the flow and disassemble as described in chapter 6.
7. Stick the test mark on after the calibration has been successfully finished.
30
®
SONIC Smart can be calibrated by every body notified for
®
SONIC Smart in the test fixture / test stand and secure it, if re-
®
SONIC Smart to the calculator or test stand as described in