Working With The Tool - Festool ETS 150/3 EQ Guide D'utilisation

6-1
6
7-1
7-2
The grinding disks and the tool-holding fi xture on
the appliance are equipped with a positive holder
[6-1].
correctly positioned before screwing it tight.

Working with the tool

too much pressure! The best sanding results are
achieved when applying moderate pressure.
The ETS 150/3 EQ gives the best surface quality
and low abrasion. The ETS 150/5 EQ provides high
abrasion with good surface quality. The sanding
performance and quality depend mainly on the
choice of the right sanding material. Festool offers
the appropriate sanding material for all applications
(see Festool catalogue or on the Internet under
www.festoolusa.com).
For safe guidance, hold the machine with both
hands on the motor housing [7-2] and on the gear
head [7-1].
We recommend the following settings on the rotary
control [2-3] for electronic machines:
5 - 6
• sanding with max. drive
• sanding old paint
• sanding wood and veneer prior to painting
• interim sanding of paint on surfaces
4 - 5
7
• sanding of thinly applied primer
• sanding of wood with sanding vlies
• sanding edges on wooden parts
• smoothing primed wooden surfaces.
3 - 4
• sanding full wooden and veneer edges
• sanding in the grooves/rebates of windows and
doors
• interim paint sanding on edges
• pre-sanding natural wood windows with sanding
vlies
• smoothing wood surfaces with sanding felt prior
to staining
• rubbing down stained surfaces with sanding vlies
• rubbing down or removing excess lime paste with
sanding vlies
8
Make sure the grinding disk is
Never overload the tool by using