Astoria GLORIA AL Mode D'emploi page 192

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 103
14.5 WATER SOFTENER REGENERATION programming
Programming of the automatic warning of water softener regeneration:
1) Enter programming until showing on the display;
2) set the amount of water (steps of 50 litres) with the keys
3) to move to the subsequent programming press the key MODE
When the machine reaches 90% of the value set on the display a signal appears for 5 seconds. When the
machine reaches 100% of the value set on the display a blinking signal appears.
i
To eliminate the blinking signal and reset the count of the litres of water to zero, with the programming
key in the ON position press the
ously until the display shows the message " 00000 ".
The regeneration control is bypassed by setting a value equal to 00000 litres.
14.6 BOILER PRESSURE programming
Service not active.
14.7 AUTOSTEAMER TEMPERATURE programming
Programming the activation temperature of the autosteamer:
1) Enter programming until showing on the display;
2) set the temperature with the keys
3) to move to the subsequent programming press the key MODE
i
The actual temperature of the beverage may differ by a few degrees from the set temperature
depending on the amount of the beverage heated.
14.8 CUP HEATER programming
Temperature programming and activation of cup heater:
1) Enter programming until showing on the display;
2) set the temperature (70-100°C) with the keys
3) press the MODE key
44
DISPLAY - ASD / DS
of the left push button panel;
to move on to the next programming.
;
.
4 keys of the left push button panel simultane-
.
;
reg. softener
00000
BOILER PRESSURE
0.0 bar is=0.0
autosteamer
65°C
C U P H E A T E R
80°C

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gloria aepGloria sae

Table des Matières