Publicité
Liens rapides
Publicité
Manuels Connexes pour Wallenstein GE605
Sommaire des Matières pour Wallenstein GE605
- Page 1 Set-up Instructions GE605 GX620 GX720 GX920 Part Number: Z97103_SI Rev Feb-2020...
- Page 2 (23 kg) or more to avoid back injury. All lifting devices (straps, slings, chains, ratchet blocks) must comply with applicable local regulations and certifications. Wallenstein Equipment Inc. cannot accept responsibility for the use of sub-standard equipment and work practices. Use lifting equipment with a capacity greater than the weight of the component.
- Page 3 GE605 GX620 GX720 GX920...
-
Page 12: Pre-Operation Checklist
Pre-operation Checklist Check that the backhoe is properly attached to the power unit. Be sure retainers are used on the mounting pins and mounting hardware is tightened to their specifi ed torque. Check that hoses and pivot points are free of any debris or entangled material. - Page 13 Bolt Torque Specifications Imperial Bolt Torque Specifications Checking Bolt Torque Torque Value The tables shown give correct torque values for various bolts and capscrews. Tighten all bolts to the torque Bolt SAE Gr. 2 SAE Gr. 5 SAE Gr. 8 Diameter values specified in the table, unless indicated otherwise.
- Page 14 Hydraulic Fitting Torque Hydraulic Fitting Torque 1. Check flare and flare seat for defects that might cause leakage. Hex Size Tube Size Flats From Finger Across Torque value Tight 2. Align tube with fitting before tightening. Flats 3. Hand-tighten swivel nut until snug. lbf•ft Inches Inches...