Cleaning The Coffee Spouts; Cleaning The Pre-Ground Coffee Funnel; Cleaning The Infuser; Cleaning The Milk Container - DeLonghi ECAM35075 Mode D'emploi

14.7 Cleaning the coffee spouts

1. Clean the coffee spouts (A9) regularly with a sponge or
cloth (fig. 26A);
2. Check that the holes in the coffee spouts are not blocked.
If necessary, remove coffee deposits with a toothpick (fig.
26B).

14.8 Cleaning the pre-ground coffee funnel

Check regularly (about once a month) that the pre-ground
coffee funnel (A4) is not blocked. If necessary, remove coffee
deposits with the brush (C5) supplied.

14.9 Cleaning the infuser

The infuser (A20) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see "6. Turn-
ing the appliance off");
2. Remove the water tank (A17);
3. Open the infuser door (A19) (fig. 27) on the right side of
the appliance;
27
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 28);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER
Clean the infuser without using soap as it could damage
the infuser.
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, put back in place the infuser by sliding it
onto the internal support, then push the PUSH symbol fully
in until it clicks into place;
Please note:

14.10 Cleaning the milk container

Clean the milk container (D) frequently as described below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (fig. 30);
28
3. Turn the froth adjustment dial (D1) counterclockwise to the
"INSERT" position (fig. 31) and pull off upwards;
4. Wash all the components thoroughly with hot water and
mild soap. All components are dishwasher safe, placing
them in the top basket of the dishwasher.
Make sure there are no milk residues on the hollow and
groove under the dial (fig. 32). If necessary, scrape the
groove with a toothpick;
17
If the infuser is difficult to in-
sert, before insertion, adapt it
to the right size by pressing the
two levers (fig. 29).
8. Once inserted, make
sure the two coloured but-
tons have snapped out;
9. Close the infuser door;
10. Put the water tank back.
29
30
32
31
33